- Wipe down the wall with warm water and a soft sponge for a light cleaning.
- To handle stains, add mild detergent to the warm water. Dunk your sponge in the solution and wipe the stained area using circular motions.
- If the stain persists, apply hairspray to the stained area. Then, wipe the wall with a paper towel using gentle, circular motions.
Performing a Light Cleaning
Use the dust brush attachment on your vacuum. Attach the dust brush to the end of your vacuum and run the vacuum over the wall. This is the least abrasive way to clean walls and should always be your first step. If you find that your walls are sufficiently clean after using the vacuum, you should stop after performing this step. Do not put pressure on the wall as you vacuum it. Lightly rub the vacuum over it and allow the suction to pick up dirt. Pick a section of the wall. Start at the top and move the vacuum from side to side, then down, until you reach the floor. When you reach the floor, move on to the next section. Use a ladder if you cannot reach the ceiling. Empty the vacuum cleaner before beginning this process.
Fill a bucket with warm water. Keep the pail of water near you while you clean so you do not need to make constant trips to the sink. As you clean, regularly squeeze dirty water out of the sponge and wet it again in the bucket of clean water.
Consider adding detergent to the water. A small amount of detergent can also be thrown into the water, just enough to create a few bubbles. However, this creates the danger of damage to your paint job. Consider starting without detergent. Add detergent if warm water does not seem to be sufficient for cleaning the wall. You should begin the cleaning process with the least abrasive cleaner available and then work up to more abrasive cleaners only if necessary.
Wet a cellulose sponge. A sponge is the least abrasive cleaner that you can use. Dunk the sponge in the water. Squeeze it to remove excess moisture. A soft towel can also work if you do not have a sponge available.
Place a towel on the ground to absorb moisture. To prevent water from dripping on the floor, place something on the floor to absorb moisture. This can be a towel or a newspaper.
Use the sponge to clean sections of the wall. As you did with the vacuum, pick a rectangular section of the wall to clean. Start at the ceiling moving left and right, then when you reach the end of the section, move further down. Keep on moving until you reach the floor. Use a ladder to reach the ceiling if necessary. Consider wearing gloves to keep your hands clean during this process.
Dry the wall with a soft towel. Once you have cleaned a section of the wall, grab a dry towel. Repeat the same motion as before to dry the wall along the section you have chosen. Pick a towel that is soft to the skin to avoid causing damage to the paint.
Cleaning Tough Stains
Make a cleaning solution. Mix a mild detergent with a bucket of water so that it begins to bubble slightly. For a tough homemade cleaning solution, try mixing 1 cup ammonia, ½ cup vinegar, and ¼ baking soda in a gallon of water.
Test the solution. Before you expose large parts of the wall to the solution, test it on a less noticeable part of the wall. Rub it in and then dry it off. If there is no mark on the wall or discoloration, then you can use the solution on more conspicuous parts of the wall. If the solution has damaged the wall, consider other options for fixing the wall. You can, for example, repaint it or hire professional cleaners. Glossy enamel paints tend to hold up best to abrasive cleaners. Flat, satin, and eggshell latex paints are sensitive to washing.
Wet your sponge in the solution. Dunk a gentle sponge in the water. Squeeze it to remove excess moisture. A soft towel can also be used, if necessary.
Rinse the spot with a circular motion. Rub the spot gently, moving the sponge in a circular motion. Clean the area with a heavy stain. Refrain from using your solution on unstained parts of the wall. This should be enough to clean most stains from beverages, like coffee or wine. If you believe that your whole wall needs a heavy cleaning, then you could use the solution throughout the room. Generally though, a light cleaning without heavy solutions should suffice for anything but a heavy stain. The risk of damage to your paint job outweighs the benefits of using a cleaning solution on the entire wall.
Repeat the process if necessary. If your solution was not strong enough to clean the spot, try using a more abrasive solution. Consider a baking soda paste or commercial cleaner. Once again, test this solution on a less noticeable part of the wall before using it. For a baking soda paste, mix ½ cup of baking soda with a few tablespoons of water. Mix thoroughly and then apply it to the sponge. A degreaser can be particularly useful when cleaning grease splatters.
Dry the wall. Use a soft cloth or a dry sponge to dry the wall and clean the solution from the wall. Rub in a gentle circular motion until the wall appears to be clean.
Cleaning Crayons off the Wall
Use a dull knife to remove the crayon. If there is a large chunk of excess crayon hanging on the wall, you must first remove the chunk before getting to the underlying stain. Use the knife to pry underneath the crayon and lift. Be careful not to scratch the wall in the process. Do not use a sharp knife.
Rub the wall with a Magic Eraser. Wet a Magic Eraser and rub the wall with it in a gentle, circular motion. This should remove any remaining chunks of crayon. EXPERT TIP Marcus Shields Marcus Shields House Cleaning Professional Marcus is the owner of Maid Easy, a local residential cleaning company in Phoenix, Arizona. His cleaning roots date back to his grandmother who cleaned homes for valley residents in the 60’s through the 70’s. After working in tech for over a decade, he came back to the cleaning industry and opened Maid Easy to pass his family’s tried and true methods to home dwellers across the Phoenix Metro Area. Marcus Shields Marcus Shields House Cleaning Professional Be careful when using a Magic Eraser on your walls. If you go too heavy or too much with a Magic Eraser, you can make the stained spot cleaner than the rest of the wall. You'll have weird-looking spots everywhere.
Wash the wall with a sponge. To pick up the last bits of stain, wet a sponge in hot water. Squeeze excess water out of the sponge. Then rub the stain in a circular motion. Consider placing a towel on the ground to absorb any spilt water.
Dry the wall. Use a soft towel or a dry sponge. Rub the wet area with a gentle circular stroke. Stop when the wall is no longer moist. Alternatively, you can put an all-purpose cleaner and a little Bar Keepers Friend on the crayon marks. Then scrub with a brush. See if it is possible to clean the crayon marks without removing a lot of paint. If too much paint is going to be lost, it may be better to paint over the dirty area.
Cleaning Marker and Pen Stains
Clean the spot with a wet sponge or baby wipe. This should be sufficient to clean up stains from washable markers. Rub gently in a circular motion. Consider placing a towel on the ground to prevent water from dripping on the ground.
Rub the stain with hairspray. If a baby wipe does not pick up the stain, spray it with hairspray. Then rub the stain with a paper towel or soft cloth. Wipe gently in a circular motion. Look to see if any of the stain was removed. If so, repeat until the surface is clean. You may need to repeat this step several times to remove the stain.
Coat the stain in toothpaste. If none of the previous steps have worked, try using toothpaste. Cover the stain in toothpaste and let it sit for ten minutes. After ten minutes, wipe the surface clean with a soft cloth.
Removing Paint from a Plaster Wall
Place a drop cloth on the ground. Removing paint will create a huge mess on the floor. You should place something like a drop cloth on the ground. Then, when you are done, you can fold up the drop cloth, pick it up, and toss the excess paint into the trash.
Scrape the paint away with a putty knife. If parts of the paint are already loose or falling off, get a putty knife underneath the paint and simply begin scraping the paint away. Use the flat edge of the scrapper so as not to damage the plaster. If you do damage the plaster, fill in the area with joint compound.
Rub the surface with fine-grit sandpaper. For small chunks that you cannot pick up by scraping, use sandpaper. Rub the sandpaper over the surface to pick up the paint.
Use a chemical stripper. Chemical strippers can discolor your wall if left on too long. However, if the paint on your wall is not sufficiently loose to scrape up on its own, you might need to use a stripper. Dip a paintbrush in the stripper and then rub the paintbrush over a section of the wall. Let the stripper sit for five minutes. Then, use a putty knife to scrape away with paint. Repeat this process until you have cleaned the wall. Ideally, once you have scrapped off a portion of the paint, you will be able to use the putty knife to remove the rest, without using a chemical stripper.
Wash the wall with a wet towel. After you have removed the paint, rub the entire wall down with sponge soaked in cool, clean water. This is step is especially important if you have used chemical stripper. If it stays on the wall, it can do damage to the surface.
Comments
0 comment